
Fluxiss has added the TD1600WM Inboard Nozzle Azimuth Thruster to the Marine Systems category of its products page. It joins the TD1600WM Deck-Mounted Azimuth Thruster and the TLTT330 Tunnel Side Thruster, so owners can now source main azimuth propulsion, deck-mounted units and bow thrusters from one supplier, on a request-for-quote basis.
An inboard azimuth thruster is built into the hull. The drive and steering gear sit inside the vessel and only the leg and propeller sit below the hull, rotating through a full 360 degrees. The ducted nozzle around the propeller raises thrust at low speed, which is what tugs need for bollard pull and what offshore support vessels and ferries need for tight manoeuvring alongside.
“An inboard azimuth thruster with a ducted nozzle propeller is now on the Fluxiss products page, completing the thruster range with hull design, powering and commissioning support.”
The deck-mounted version suits barges and pontoons that need power added without major hull work. The inboard version is the choice for new builds and conversions where the thruster is part of the vessel design from the start. Paired with a prime mover such as the WP6C250-25 marine diesel engine, it gives a complete propulsion line.
Supply is backed by engineering. Our Naval Architecture team can check powering, hull openings and thruster foundations, and Commissioning and Audits can support installation checks, sea trials and handover.
To request a quote, open the thruster page on the products page or contact Fluxiss with your vessel type, required bollard pull or speed and class society.
Fluxiss Team contributes updates insights to the Fluxiss content library.
Related articles.
Let's Build Something Great Together.
Partner with Fluxiss for engineering that holds up - under pressure, under load, under scrutiny.


