
CFD Feasibility Study of a Grease Distribution Network for Bearing Lubrication
Transient ANSYS Fluent study showing a proposed grease network could not reach its four bearings, with redesign recommendations before fabrication.
Challenge
A branched piping network had to deliver highly viscous grease (100 Pa·s) from a pump to four bearing outlets, and the client wanted to confirm it would work before fabrication.
Approach
The internal fluid domain was extracted from the SolidWorks model and simulated as a transient flow in ANSYS Fluent with a decreasing inlet flow schedule, monitoring outlet pressure and mass flow at all four bearings.
Result
Total pressure drop was 578,850 Pa and outlet mass flow was zero at all bearings, because network resistance far exceeded pump pressure. The study recommended higher pump pressure, a lower length-to-diameter ratio or a redesigned manifold.
Scope of Work
- Fluid domain extraction
- Transient internal flow simulation
- Outlet flow and pressure monitoring
Deliverables
- CFD technical report with redesign recommendations
Similar projects

Aluminium 6061 Trailer Structural FEA for Static, Dynamic, Braking and Turning Loads
ANSYS FEA of a 7×12 Al 6061 trailer across four load cases: all passed (minimum FOS 1.255), with critical joint and weld recommendations.

96-Inch Cone-Cylinder Carbon Steel Pressure Vessel Analysis in PV Elite
ASME VIII Div.1 analysis of the 96 in OD SA-36 DF-3 vessel with cone-to-cylinder transitions, ASCE-7 wind and UBC seismic, MDMT 20°F.
Let's Build Something Great Together.
Partner with Fluxiss for engineering that holds up - under pressure, under load, under scrutiny.